1959 Scott/McCulloch 10hp

This topic has 3 replies, 3 voices, and was last updated 1 month, 1 week ago by Buccaneer.

Viewing 4 posts - 1 through 4 (of 4 total)

Author

Posts
September 23, 2026 at 10:04 pm #329004
Geer Pyron
Participant
US Member
Does any have crank shaft bearing/seal assemblies for a ‘59 Scott 10hp? Both upper and lower? Maybe some suggestions for a source or alternative? Thank you, Geer in Gainesville

JMGP
September 24, 2026 at 1:55 pm #329042
JOSEPH BRINCAT
Participant
US MEMBER PAY BY CHECK
Do you have part numbers? that would be a big help.

Joe B
September 24, 2026 at 2:20 pm #329048
Geer Pyron
Participant
US Member
Unfortunately, no. I’ve been looking for a parts list to get the p/n but no luck so far. But even then, the seal is integral to the bearing carrier so the p/n would be for the whole assembly. As far as I understand it anyway. I really only need the seal.
I’m thinking at this point I’m going to just get the closest sized Timken seal that I can.
but thanks anyway.
g

JMGP
September 24, 2026 at 5:41 pm #329057
Buccaneer
Participant
US Member
Here’s a couple of pages from a 1959 10 hp Wizard manual.
I would think it’s the same as the Scott for the most part.

Prepare to be boarded!
Author

Posts

Viewing 4 posts - 1 through 4 (of 4 total)

You must be logged in to reply to this topic.