Home › Forum › Ask A Member › 1921 Elto Lightwin Model F

Viewing 3 posts - 31 through 33 (of 33 total)
  • Author
    Posts
  • #303616
    Aidan Smith
    Participant

      US Member

      Yes, that is exactly what I have going on.

      I do think that in my case, finding a new powerhead would be best because this motor has fallen over at some point (may be why it has a different tank), and two out of the three castings that the tank bolts on to have snapped.

      The timer has been capped, and I need to make new wires for the coil. Other than that, the lower section spins freely and should be all ok.

      Where should I start? I spent about 3 months working on buffing the mid section, and I’ve gone through there. o

      Any ideas where I can find a powerhead?

       

      1952 Blue Streak "B-Stock Runabout" - 1952 Mercury KG7Q
      1955 Feather Craft Vagabond - 1956 Mercury Mark 55E

      #303626
      Sam M.
      Participant

        Canada Member

        I agree that you should try to save the powerhead!  Snapped metal mounts can be welded and rethreaded.  Just work at unseizing it slowly and methodically.  Apply lots of penetrating oil and and be patient!

        1 user thanked author for this post.
        #303627
        Aidan Smith
        Participant

          US Member

          Yes, I have been trying that. Chances are slim, though. I can see the rings bulging into the exhaust ports, I think it was ran with absolutely zero oil. One of the rods is cantilevered and belt as well, but I am not giving up!

          1952 Blue Streak "B-Stock Runabout" - 1952 Mercury KG7Q
          1955 Feather Craft Vagabond - 1956 Mercury Mark 55E

          1 user thanked author for this post.
        Viewing 3 posts - 31 through 33 (of 33 total)
        • You must be logged in to reply to this topic.