Re: Using a car coil outside the 2 stroke block

Home › Forum › Ask A Member › Using a car coil outside the 2 stroke block › Re: Using a car coil outside the 2 stroke block

September 13, 2016 at 7:23 pm #43982
mercuryman
Participant

    Connect battery ( – ) to ground, Ground the coil to block, connect battery ( + ) to coil +, connect coil – to points, unhook motor coil and leave condenser connected. Put a switch in the + circuit and depending on the coil used you may need a ballast resistor. If this is a two cylinder with two points , you will need two sets of coils.