Home › Forum › Ask A Member › OMC vs HF flywheel puller › Re: OMC vs HF flywheel puller
July 30, 2016 at 5:35 pm
#41239
quote Wedgie:
quote Steve A W:
Just a little quick tip.
On my puller bolts I put electrical shrink tube on them
so there is only 7/16 inch of threads showing.
Can’t run them in too far with this.
On my puller bolts I put electrical shrink tube on them
so there is only 7/16 inch of threads showing.
Can’t run them in too far with this.
Steve A W
3/8 OD poly tubing also screws right onto the threads using a pair of channel lock pliers. Makes a nice shoulder but not one you want to tighten up against as it will move.