Reply To: Would you use this lower half of gear case oblong bolt hole ?

Home › Forum › Ask A Member › Would you use this lower half of gear case oblong bolt hole ? › Reply To: Would you use this lower half of gear case oblong bolt hole ?

September 24, 2026 at 8:44 am #329029
Dale
Participant

    US MEMBER PAY BY CHECK
    outboardnut wrote:

    I did not fill the hole and drill a new hole because-
    I do not have the means to drill EXACTLY where the hole was previously.
    The plastic bolt did not get stuck.
    Even if it did -I could drill it out. That is why I used plastic
    A 1955 Johnson 25 HP does not have a gasket under the water pump housing.

    I stand corrected!   I should have reread the original posting.

    dale