Home › Forum › Ask A Member › Thx for your replies with helping to set points gap › Reply To: Thx for your replies with helping to set points gap
So after putting some fuel into each cylinder, my 1966 5hp evinrude did start. It does have the old points not the new BRP points. So now I will try using the choke and fuel tank. I did rebuild the carb. It was leaking badly from the bowl. If it doesn’t start now, I will investigate the fuel delivery issue. I am disappointed with my new BRP points. Not sure why I cannot gap them. I will try everyone’s suggestions if I have to remove that aggravating flywheel again. Took about 8 hours of bending gear puller bolts and using a 5 lb hammer to get it off. Wow
OK, you really need the OMC flywheel puller kit for this. Using the wrong puller can damage parts and cause injury….