Re: Johnson Model A flywheel removal trouble

[willyboy]

Thanks Tubs,it looks like the coil and parts are original as they look like the pic you posted. Unscrewed the bakelite caps and cleaned the copper contact spring and brass stud,cleaned some of the gunk off of the copper plate in the bakelite tubes and reassembled all. Going to tighten the flywheel down and check for spark tomoro,got my new repro cloth covered wired installed. Hoping for some snappy blue lightning tomoro! Also managed to get hold of 7 nos c-7 spark plugs,of which this model used. I need to find some copper compression rings for the plugs as they didn’t come with any but still got a decent deal on them. Not much left to go to hopefully make this a runner,clean the varnish from inside the fuel tank and make a new inner copper muffler and should be ready for a test drive.