Re: Johnson Model A flywheel removal trouble

[willyboy]

Took a few hours,a level and some patience but I managed to straighten the mag plate and get it cleaned up. Also found the source of the dragging and it was a loose block of brass under the flywheel between the magnet ends,tightened the screws and it went away. Points were dirty and corroded,polished them up and they may work but really need to be replaced. I need to order some 9mm cloth covered plug wire as the roll of 7mm I have is a tad small. Thanks too all for the help,look forward to hearing this one run,never worked on one this old.