Home › Forum › Ask A Member › Stripper bolts size and TPI for 81 Evinrude 15 › Reply To: Stripper bolts size and TPI for 81 Evinrude 15
June 6, 2022 at 10:40 am
#261046
I have seen most if not all those videos. The process is familiar to me and I have gear puller and harmonic puller, but the latter uses the three threaded holes adjacent to the center nut for purchase points. The OMC tool for this is a harmonic tool also. I just don’t have these 3 bolts to fit the thread size and pattern of these holes(Stripper bolts). I hesitate to use a gear puller on the edges of the flywheel(warpage). I was hoping someone knew the exact size and pattern of these bolts.
T