OK… good, now we are on the right track. Not to presume, but there is a possibility that Donald can find and attach new spark plug wires to the coil. Do not attempt to “screw” into the coil. Some careful probing may uncover the termination of the very fine secondary winding. Normally that fine copper wire is terminated to a short piece of braded wire or a tab of copper. If you can find that or the actual end of the coil wire, carefully solder an attachment tab, secure and wrap the repair area so that nothing moves.
Although it would be a good idea to test the continuity of the secondary winding to ensure that it is good, before investing too much time. On this type of coil, test continuity from one spark plug wire lead to the other,, should be about 6,000 to 7, 000 ohms
Joe B
-
This reply was modified 4 years, 6 months ago by
.
-
This reply was modified 4 years, 6 months ago by
