Re: Johnson of Oakland, Kaminc, and St. Annus Props

Home › Forum › Ask A Member › Johnson of Oakland, Kaminc, and Stannus Props › Re: Johnson of Oakland, Kaminc, and St. Annus Props

November 28, 2015 at 10:58 pm #27763
Mumbles
Participant

    If the bore is tapered, they’ll be for inboard shafts but the smaller props also used a straight bore with a pin.

    The old rental clinker boats from around here had small props on the brass shafts. I guess it was a good match for the single cylinder Briggs motors that were spinning them.

    I have one with a short piece of shaft out in the shop so I’ll measure it when I go out there.