Re: Advice for cutting a flywheel off

[wetwillie]

I couldn’t agree more about the quality of the OMC puller as compared with any other puller I’ve ever seen. The shouldered bolts are also excellent. However, I snapped those same bolts early on when I used an impact wrench. Thats why I turned to Fastenal to get me a set of shouldered bolts that were even stronger. It was one of those that I had to remove yesterday after it too snapped. Next step is to try heating the flywheel again as hot as I can. I figure I have nothing to lose at this point. I’ll cut my losses and list the motor on CL if I don’t succeed.