Re: OMC Gear Case

[RICHARD A. WHITE]

I would add that while drilling a new hole would be faster, imagine if you drilled it in the wrong location??? Like too close to the gears, then it would not go together…
I can duplicate the jig I made, pretty simple and then you know the hole is correct.. I have drilled enough holes in aluminum to teach me that if it aint jigged properly all bets are off on where that hole will wander to, notice I did not say IF it moves…

Your mileage may vary, as not everyone has the experience to do that properly….

http://www.richardsoutboardtools.com
classicomctools@gmail.com