Re: OMC Gear Case

[Bob Wight]

I pulled one by center punching the pin, drilling a hole, threading a self tapping screw into the pin, then pulled on the screw head with pliers. Just prior to pulling on the screw head, I applied some heat to the housing to help expand the pin hole just a bit. Made a new pin from some rod stock I had. Takes a lot of patience to get this done. If you can get the pin punched exactly dead center, guess you might be able to just drill the pin out kind of like drilling out a broken head bolt.

Here’s a link where I got the idea:

https://conductorjonz.wordpress.com/201 … p-day-two/

Scroll down the page a little ways to see how this guy did it.

Bob

1937 Champion D2C Deluxe Lite Twin
1954 Johnson CD-11
1955 Johnson QD-16
1957 Evinrude Fastwin 18
1957 Evinrude 3022
1958 Johnson QD-19
1958 Johnson FD-12
1959 Johnson QD-20
1982 Evinrude 25hp

“Every 20 minute job is only a broken bolt away from a 3-day project.”
"Every time you remove a broken or seized bolt an angel gets his wings."