Home › Forum › Ask A Member › Carbs needle clip–1972 V4 › Re: Carbs needle clip–1972 V4
August 20, 2018 at 1:14 am
#81467
I work on small power equipment at work and many of the needls that have the groove, but no clip are meant to slide into a "slot" in the float. Many of the new plastic floats have a raised section that has an inverted "T" slot in it to hold the float end of the neede.
Not sure if that is the case here, but I have never used a Sierra replacement float to see if that might be the way that the make them.