Re: Why is my HD25 overheating?

[shane-r13]

quote gjonz:

That wedge shaped grommet is what I was speaking of. I know you trimmed it at the bottom, but look up through it and make sure it has not swollen closed a bit. Every little bit helps. The tube may still go into it, but the hold may be swollen partially closed. Should be the same all the way through the bore of the hole.

Greg

Ok I’ll take a look up inside. I did run a wire up it and it went. How do you peer up it? The prop shaft seems to be in the way. Should I remove the foot from the mid section?