Re: Johnson AT-10 gasket question.

Home › Forum › Ask A Member › Johnson AT-10 gasket question. › Re: Johnson AT-10 gasket question.

July 5, 2018 at 5:50 pm #79074
Buccaneer
Participant

    US Member

    From what I remember, you just cut out a power head to lower unit gasket
    with the three stud holes, center hole to go over the driveshaft bushing,
    and one water hole , circa 3/8" diameter, in line with the water feed in the lower unit.
    The exhaust gasket was a separate gasket.
    Doubt seriously if you’d find a ready made gasket.

    Prepare to be boarded!