Re: 1953 sea king 5 model 35GG-9015A

[chris-p]

Step 1 would be to test compression. If good, then proceed.

To test compression, remove the plugs, ground the plug leads, and pull over 6 to 8 times each lead. Should be the same, and on that model, around 70 to 95ish psi.

Then test spark. Likely wont have any, but don’t fret. Pop the flywheel, dress the points, clean with acetone and try again!

I would then clean the carb and fuel lines, replace as needed, clean the tank/filter/petcock.

Change the water impeller. Then barrel test her!

Run the fuel/oil mix at at least 24:1, I prefer a little richer on the 5hps, about 16:1.

Let us know how it goes, and post some pics!