Home › Forum › Ask A Member › Mcculloch 4hp no start › Re: Mcculloch 4hp no start
If I can get it running, then I know that what I have works. Ag that point I’m going to take the lower plate off, that goes under points, and put it on mine since it is warped. One issue might be that I know that not all of the gaskets are available anymore. Overall yes I want to have one, good running, decent engine that I can say that I brought back from the grave. I have a few mcculloch chainsaws that I’ve done the same things with and had to do a complete tear down. They run like champs now. This motor is just being a little bit of a pain.
Two questions. My tank has a dent on the side towards the opposite end of where the bung hole is. What is the easiest way to get this out. I’ve been thinking of using a air bladder and stuffing it in the tank, pump it up and try to push dent out. I’m also thinking this could break the seams. Secondly, what is correct lower unit oil to use? Will 80w90 be ok?