Re: Mcculloch 4hp no start

[joesnuffy]

I see what your saying. So the exhaust leaves exhaust port thru like a diverter then thru the baffle then exits thru the bottom of the outboard near the foot. All that is of course is clear and non-restricted I’m sure you have checked that out. No mud or nests down low where the exhaust leaves the foot? The reeds look good enough now to get the motor to hit. The ignition is firing and you know where to set your lever to make timing correct. Seems like it would hit at this point if you have adequate compression.

Once you get it re-assembled let us know if you get it to hit if not have you tried a tad of gear oil in the cylinder yet? Also I would like to know what your compression gauge shows with the oil in cylinder for psi?

Hope that helps,
Joe

ps glad you hear you joined the club and your waiting on info packet. Also your name should appear in red color now you have joined . You may have to contact the administrator on that. It also gives you access to more areas when you click on Board Index above.

https://SecreLocal.com - - No Verify - Anonymous Adult Dating -