Hey Don, I just noticed something…. I went out to try to back off that throttle cam. I inspected the carb throttle plates a bit closer. I noticed if I focused on the top carbs plates while turning the top carbs cam forward(down) that the plates fully closed. Oddly the adjustment screw for this (which is on the middle carb cam has been covered with gasket sealer ? Surprised I hadnt noticed this before. I believe if I loosen this I will be able to change the adjustment of the arm that guides all of these plates. Is it a bad idea to do this without making any other changes ? This clearly shows the position of the throttle cam on the roller. Not touching, so it is not pushing the plates open. You can also see the covered screw.
