Re: Help with 65′ Evinrude Fisherman 6HP

[JACQUES]

measure booth clip to frame ground
should see 4-7kohms if not 4-7Kohms then re-measure from HV coil pin to frame ground if ok….. bad plug wire
if not OK measure HV pin to black wire just in case the mag plate is not grounding to engine block properly
if ok to black wire but not engine frame find out why the mag plate is not grounding properly

you must have 4-7kohms to engine block from the booth clip

measure plug wire end to end should be 0 ohms if you used proper metallic wire (no carbon)

something is strange here… 2 bad coils with same symptoms is very unlikely…. short you meter probes to ensure you read 0 ohms before starting analog or digital are both ok

Joining AOMCI has priviledges 🙂