Re: amazingly…cheaper for 4 !!

[fisherman6]

I agree Dan. It is the ratio of the windings that matter in the step up/dn calculations of a transformer or a coil. Using resistance to estimate that truly leaves too many variables unknown. The wire gauge is unknown as well, but knowing that wire gauge determines the amount of raw material used to produce the coils, I’m willing to bet it’s quite small. If we knew it, we may be able to predict the windings ratio more closely, but it would still be only an estimate. I’m going to try them in another motor sometime hopefully fairly soon and see if I get the same results again. All this said, I still ordered some more to have on hand.
-Ben

OldJohnnyRude on YouTube