Re: If I have a wiring error, I simply can’t find it…

Home › Forum › Ask A Member › If I have a wiring error, I simply can’t find it…UPDATE: FIXED! › Re: If I have a wiring error, I simply can’t find it…

February 13, 2018 at 2:44 pm #70978
JACQUES
Participant

    humm…. like I suggested.. if I read this correctly…. no plugs fire when both kill wires shorted towards the engine side… this is good 🙂

    disconnect kill wires and measure resistance back to the kill switch… is it 0 ohms in kill mode ??

    now a second test…….. measure individual wires to the kill switch with…..reference to ground

    measure each wire with ground in kill mode and run mode …

    I suspect one wire may be getting grounded in kill mode without the two wires being linked together inside the switch during kill mode
    this condition if it exists… would kill one set of points leaving the second one running

    jmho

    Joining AOMCI has priviledges 🙂