Home › Forum › Ask A Member › 1936 K-80 › Re: 1936 K-80
February 13, 2018 at 12:50 am
#70954
The instruction on the tank state, open needle valve one full turn, set choke to extreme right, set timing lever a little right of center, press down float pin till fuel drips from overflow pipe. Spin motor with rope, when it starts turn choke back to original position. Advance magneto to high speed and close needle valve to where motor runs fastest. When the motor is warm it should start without opening needle valve.
Good luck, hope this helps. I’m working on a K-80 now.