Home › Forum › Ask A Member › Well, the Fastwin is "running" › Re: Well, the Fastwin is "running"
In general I change the impellers immediately as well, but the vanes looked 90% as good as a new pump, couldn’t really see any wear on them. Plate and pump housing looked ok, some wear but I have other motors that run fine looking like this one does. Hole is open, grommets were flexible and looked good. Didn’t blow open the passages. It is completely submerged.
Carb was just taken apart, gone through and cleaned. I mentioned in another thread that I noticed some damage to the low speed idle needle, but I cleaned it up and I am not convinced that is the culprit as it was acting like this before I tore the carb down and checked it. Haven’t checked sync yet.