Home › Forum › Ask A Member › Points repair? › Re: Points repair?
Mumbles, One would have thought A-80 would be found after
A-75 in the list. I can’t see stuff on the grocery store shelf
when it’s right in front of me either!
Bill, Good idea with the tungsten carbide.
I’ll have to experiment sometime.
I did not find any un-used points from my
LT & DT Johnson projects, so I’m going to
use the contact from the Model A Ford points
for now, but will scrounge up the correct points
to have on hand.
The old square / rectangular condensers
tested at .28 and .29 mfd. Believe I read
that .22 is correct for the A-80.
I have two .22 axial caps, but the trick
will be to see if I can install them in the
original spot on the bottom side of the mag plate.
On the axial caps, does it matter which end is
"grounded"?
Thanks.
Prepare to be boarded!