Home › Forum › Ask A Member › confused as hell using a timing fixture on a low-tension magneto › Re: confused as hell using a timing fixture on a low-tension magneto
June 4, 2015 at 1:51 am
#17553
Wanted to confirm – you just reverse the stampings on the timing fixture. Motor popped off after 3 pulls, and have just tuned in the timing. Now I have to chase down a cooling system issue…1st run, ran cold. Shut the motor down to do a link ‘n sync, run it again, now it’s not pumping water and was building toward a progressive overheat.
Thermostat and/or impeller time (impeller looked OK prior to running, but looks are deceiving)!