Re: pump impellor – WD3/KD3

Home › Forum › Ask A Member › pump impellor – WD3/KD3 › Re: pump impellor – WD3/KD3

October 16, 2017 at 3:29 pm #66272
JOSEPH BRINCAT
Participant

    US MEMBER PAY BY CHECK

    I said that I would report… REPORT: I believe that I have found a replacement for the 46 Wiz/ Merc impeller. Thanks to the size charts that were posted, a Yamaha & Merc 2 HP 1984 – 02 impeller is the correct diameter and thickness. The hub bore however is small and needed to be bored out to 1/2" . Since the Wiz drives the impeller from two key slots on the face of the impeller hub the hub needed to have the two key ways cut in… which I did. All appears to be OK, awaiting a water test and final report… perhaps a tech article for the "Outboarder’" as well.

    Joe B