Home › Forum › Ask A Member › Evinrude Exorcist needed… › Re: Evinrude Exorcist needed…
October 8, 2017 at 1:14 am
#65880
The hole that is epoxied should have a Welch plug in it (as I believe you know from what I read in your post). Was the epoxy so far into that passage as to block water flow thru the head at the lower cylinder where it exits into the exhaust housing? Is that part what you mean by the "out" hole? It appears the bottom cylinder overheated due to no water flow. Did the heat do any further damage to the lower cylinder? Don also replied while I was typing so please excuse any duplicate questions, etc.
-Ben
OldJohnnyRude on YouTube