Re: Eisemann 71L magneto

[Anonymous]

The thing I remember seeing in articles was to cut half the laminates in one place, and half in a different place, so you can reassemble them with the joints alternating. Using ][ to show where the laminations have been cut:

code :------------------][----
---][-------------------
------------------][----
---][-------------------

Assuming the new coil leaves enough space on either side to run a bolt thru to keep the stack together.

Putting the widest (old center) laminations on the outside of the stack might give you a square enough profile to hold a coil that has a square hole….