Re: Neptune 1.7hp Mighty Mite WC-1 Question

Home › Forum › Ask A Member › Neptune 1.7hp Mighty Mite WC-1 Question › Re: Neptune 1.7hp Mighty Mite WC-1 Question

September 28, 2017 at 8:21 pm #65501
frankr
Participant

    I think there is a small hole drilled in that notch, right? The hole and notch provide a vacuum source from the carburetor side of the reed plate to suck oil through the upper main bearing. If it were not for that, the bearing would not get enough oil, since it doesn’t run uphill by itself.

    The plate goes as you show it, notch at the top.