Re: 1963 Fastwin Upper Water Tube Grommet Replacement

Home › Forum › Ask A Member › 1963 Fastwin Upper Water Tube Grommet Replacement › Re: 1963 Fastwin Upper Water Tube Grommet Replacement

September 15, 2017 at 10:35 pm #64950
chris-p
Participant

    Your problem is that the 5/16 rod wont allow the "tabs" to depress, allowing the grommet to fit into the hole, until they can expand back out once seated. I milled out areas on either side of my tool, allowing the area around the tabs to depress just for this reason.