Home › Forum › Ask A Member › Johnson QD-14 issue…. help! › Re: Johnson QD-14 issue…. help!
August 7, 2017 at 5:04 pm
#62679
Bucc,
It sounds like the screws that are holding the mag plate to the retaining ring are just a little too long. There should be a split lock washer under the short screws that pass thru near the points. I have had to use flat or toothed washers under the long ones that pass thru the coil laminations before too. In fact, I picked up a QD-13 at Tomahawk that I had to do this to so the mag plate would turn. This may be the only thing causing your bind.
-Ben
OldJohnnyRude on YouTube