Upon further inspection i noticed some very clean oil leaking from what appears to be holes near the bolts holding the lower unit here are some pictures – i am not sure if these are factory or not as i am just getting familiar with these older motors, and there is a lot of pitting on the fin, so i am worried. where do i start with this? it was laying down for a while (10 years) and I just put it upright. i am amazed by how clean the oil is.
The flat piece is defintiely moving and seems to be going down. can i tell if it hits the valves without tearing down the top of the motor?
how do i get the glass fuel bowl apart..lol?
