Re: 1969 25hp Evinrude Low Speed carb and flywheel torque

Home › Forum › Ask A Member › 1969 25hp Evinrude Low Speed carb and flywheel torque › Re: 1969 25hp Evinrude Low Speed carb and flywheel torque

June 24, 2017 at 8:43 pm #60256
mas
Participant

    US Member
    quote fleetwin:

    So, you want to make sure #28 is in place, or the engine will run lean at low speeds….

    I’m finding it difficult to ensure that this in place…I’m sure OMC had a special tool?? I ended up using the back end of a drill bit to line it up…who knows if it is seated properly. I know that it is square from visual inspection, but unfortunately I did not take measurements to measure depth of seating.

    Mas