Home › Forum › Ask A Member › flywheel tool? › Re: flywheel tool?
i used an rusty small diameter chain,wrap it around more than once and tie off the end to the motor stand.It may slip a bit ,but when it does catch it works good. Get the chain links into the rope groove for a good bite.
I used it to remove and install the flywheel on my 25 hp at 105 Ft Lbs.
I have also made a tool to hold the fly wheel still, out of a piece of angle steel manufactured with all those holes and slots pre drilled,like an erector set piece. Put in two bolts with nuts and washers so that the bolt end will fit in the threaded holes or the non threaded recesses on the flywheel,like on a 9.9/15.
"Some people want to know how a watch works, others just want to know what time it is"
Robbie Robertson