Re: Gear handle/upper shift mechanism too stiff 65 Chrysler 6hp

Home › Forum › Ask A Member › Gear handle/upper shift mechanism too stiff 65 Chrysler 6hp › Re: Gear handle/upper shift mechanism too stiff 65 Chrysler 6hp

May 9, 2017 at 2:47 pm #57348
garry-in-michigan
Participant

    An arms dealer should have a bore brush that can clean out the corrosion so the shift shaft should spin like it’s on rollers. If there is enough material, I would add a grease fitting. Periodic greasing should keep the corrosion at bay. . . 😉