Oltimer, are you talking about an O-ring installed in a groove
machined in the crankcase bottom journal, or in the
cap that bolts on the bottom of the crank case?
P.S.- those 1-3/8" diameter pistons sure are cute!
Thanks.
P.S.- I measured the crankshaft "mains" at .680
on my veneer caliper, but maybe I need to go
digital……… those little lines are getting hard
to read!
P.S.S. – I had a link to SKF where you could search for a
seal by part number or "inputted" desired size.
It’s not working anymore.
Anyone know of a similar web site?
Attachments:
Prepare to be boarded!