Re: Gettin into the lower unit

Home › Forum › Ask A Member › Gettin into the lower unit › Re: Gettin into the lower unit

May 18, 2015 at 4:16 pm #16354
hag
Participant

    Well I am re-assembling everything but having problem with the bearing carrier. After inserting it and splines all lined up and turns smoothly, I put on and tighten the cover nut with the spanner wrench then the drive shaft is seized tight. I loosen the cover nut then drive shaft starts to move. Can you over tighten the cover nut and push the carrier onto the pinion gear?