Re: 1969 Fastwin shift linkage adjustment?

[bullie]

quote Fisherman6:

That 3/16″ could be enough to make it jump out. Hope it works! That’s quite a bit of slop for that clamp even if it’s loose since the screw fits the groove in the shift rod. Here’s hoping it works out though.
-Ben

That did confuse me when I looked at the groove in the shift rod. I don’t know how it was slipping but it definitely was. I worked the shift lever through all three notches a few times and it seemed to be holding good. It was locking into forward and hopefully it does the same for reverse.