Re: Top speed with 18hp Evinrude on 14′ aluminum

Home › Forum › Ask A Member › Top speed with 18hp Evinrude on 14′ aluminum › Re: Top speed with 18hp Evinrude on 14′ aluminum

February 19, 2017 at 3:59 pm #53267
Mumbles
Participant

    Hold on a moment before you do anything drastic. The last step on the brass plate might make contact with the block at WOT, not the shift lock lever. I’m sure some models do. There’s a few 18’s in the garage so I’ll take a look when I go out there.

    Do you know if any mag parts have been swapped around in the past? There’s a reason that shift lock lever has been shortened and the motor not making full RPM could be it.