Re: 54 Fleetwin twist grip problems

[chris-p]

The tabs on the friction block are likely not aligning with the notches on your tiller.

In your last pic, see the 2 cut outs straight down from the hole in your bar? There is another notch 180 degrees away on the other side.

Take the white nylon friction block out from inside your tiller grip.

Slide it into the tiller handle, aligning the tabs in the block with the notches in the tiller.

Then slide on the grip and screw to tighten.

If you are not using the tiller handle, (remote steer) you remove that white friction block. It keeps the throttle constant while using the tiller.