Home › Forum › Ask A Member › RDE-18 powerhead to exhaust plate/gaskets › Re: RDE-18 powerhead to exhaust plate/gaskets
February 6, 2017 at 9:53 pm
#52540
No holes drilled. The plate installed has the two small restriction tubes. I think the only thing that was modified was the front pan. If this would have came up a week or two ago I would have been able to get some pictures but as it is right not it is back together. I will be disassembling again to repaint though so I can do whatever mods I need to then. I did have the crappy lip style lower seal but changed that to the carbon type.