Re: RDE-18 powerhead to exhaust plate/gaskets

Home › Forum › Ask A Member › RDE-18 powerhead to exhaust plate/gaskets › Re: RDE-18 powerhead to exhaust plate/gaskets

February 6, 2017 at 1:13 am #52483
William Jatzek
Participant

    US MEMBER PAY BY CHECK

    I did not use the flat plate change over kit I bought that required drilling. I replaced the original deteriorated 2 tube plate with a good used one. Obviously the engines will run good either way ( 60 years ). I was afraid to use my kit but I learned today it is fine to use it with no harm if I so choose.