Home › Forum › Ask A Member › 1954 Evinrude Super Fastwin 15 › Re: 1954 Evinrude Super Fastwin 15
Welcome!!
You have found a very nice motor at 67 pounds it packs hp. Tip on pulling the flywheel, use a harmonic balance puller but NEVER run the three screws too deep into the threads, It will hurt the magneto parts. On the gearcase be sure to replace the shift shaft O-ring, That guy always leaks.
You will find the gearcase straight forward easy to service. Look at the shift dog on the prop shaft for damage. Look for fishing line on the shaft too. If that seal is wet it must be replaced as well. I’m sure everyone has covered most of it so I’ll go. Just be sure it has compression before putting any money in to it too.
BE SURE to read the inside hood instructions. It has the correct oil mix written in the instructions, one quart of premix oil to five gallons of gasoline. I cheat, I own the same motor & have read it too. Equals 20/1 ratio.
HEY PAPPY, What prop were you running?