Re: How to repair an eccentric lobe

Home › Forum › Ask A Member › How to repair an eccentric lobe › Re: How to repair an eccentric lobe

February 3, 2017 at 1:21 pm #52336
ADAM GIBB
Participant

    Canada Member

    Thanks everyone. I will try to round up a local machinist that will take this on. Hard to find people that will do one off jobs around here.

    How much could be removed, before it would be necessary to build it back up? If material is removed from the lobe all around, the pump will operate, but lower in the travel. would .020 be OK, or if that much is removed, should it be built back up to standard?