Home › Forum › Ask A Member › OMC BUSHING 303140 › Re: OMC BUSHING 303140
January 30, 2017 at 11:32 pm
#52165
Mumbles, if I remember correctly, the bushing wall is only about .035.
I wasn’t sure if a person could machine one on a lathe or not.
Guess anything is possible!
I looked at the bushing again today. Most of it’s wobble is the bushing
rocking in it’s bore, rather than the gear stud loose in the bushing.
I may just try epoxying the bushing in it bore and call it good…..
then again, making a bushing sounds like a fun challenge!
Thanks.
Prepare to be boarded!