Home › Forum › Ask A Member › PICO Ignition Wire: Good? › Re: PICO Ignition Wire: Good?
Hey Chuck,
I agree with Mumbles about this wire being a bit flimsy and it does have only a single insulation layer. That said I have a roll of it and I have been using it on my motors that have needed new wires. So far so good with it. I have not had any problems yet. The price is right, but I may go for a more robust wire when I run out of this. If there is any place this looks like it may rub or wear, I will put a piece of heat shrink tubing over that area for some added protection.
I have not tried the BWD or the Standard yet. A spinning flywheel will wear it’s way through most any plug wire insulation in a fairly short time.
-Ben
OldJohnnyRude on YouTube