Re: Correct Crankshaft for 1956 RDE-18

Home › Forum › Ask A Member › Correct Crankshaft for 1956 RDE-18 › Re: Correct Crankshaft for 1956 RDE-18

January 14, 2017 at 9:19 pm #51044
olcah
Participant

    US Member

    Adam, Measurements are scaled with a Starrett steel rule having 0.020 in. increments.

    302530: Scaled from bottom of hole to top (narrow end) of short taper. 0.330 Really hard to scale as start of taper is hard to determine. I could be out .030 easily.
    Scaled from bottom of hole to bottom (wide end =start of bearing surface) of short taper. 0.400

    203655 same locations
    0.310 really hard to scale as start of taper is hard to determine. I could be out .030 easily.
    0.440

    Let me know if you need other dimensions.